Possible cause and solution of an ADSL Internet faults.
1. Make sure that other device using the same phone number is filtered. Modem does not need to be connected via a filter. You may hook up the modem straight into the wall outlet.
2. Distance from the exchange exceeds maximum guaranteed distance. Make sure you contact your ISP.
3. Filter is defective. Replace filter
4. It could be a faulty outlet. Check other outlets in the house (If applicable), other wise get a local electrician to check the outlet.
5. Interference from other electronic devices such as Halogen lights, AM radio, or cordless phone. Place the modem away from any Halogen lights and away from the cordless phone base.
6. congestion on route to destination. Check to see if anyone else with your ISP has started a thread about congestion. You may also run a trace route to dslreports.com and post your results along with speed-test and tweak test results.
7. Make sure that the phone wire does not exceed the 3 meters.
8. Incorrect MTU/RWIN settings. The correct MTU for PPPOE is 1492.
9. No more than 4 devices should be connected into the ADSL phone line. If you require additional devices, then you need to install a central filter.
1. Make sure that other device using the same phone number is filtered. Modem does not need to be connected via a filter. You may hook up the modem straight into the wall outlet.
2. Distance from the exchange exceeds maximum guaranteed distance. Make sure you contact your ISP.
3. Filter is defective. Replace filter
4. It could be a faulty outlet. Check other outlets in the house (If applicable), other wise get a local electrician to check the outlet.
5. Interference from other electronic devices such as Halogen lights, AM radio, or cordless phone. Place the modem away from any Halogen lights and away from the cordless phone base.
6. congestion on route to destination. Check to see if anyone else with your ISP has started a thread about congestion. You may also run a trace route to dslreports.com and post your results along with speed-test and tweak test results.
7. Make sure that the phone wire does not exceed the 3 meters.
8. Incorrect MTU/RWIN settings. The correct MTU for PPPOE is 1492.
9. No more than 4 devices should be connected into the ADSL phone line. If you require additional devices, then you need to install a central filter.
没有评论:
发表评论